How to Maintenance diamond polishing pads?

In the face of the phenomenon of abrasion and weathering, the current effective solution is to clean up the dirt on the surface of the stone, and then wax the surface. This way will only protect the new diamond water grinding sheet, and appropriately delay the speed of abrasion and natural weathering. However, for the abrasive and weathered diamond grinding pieces have played no role, and the effect is equivalent to applying varnish on the decaying wood, so it will not play any effect at all, and the wax film formed in this way has a relatively short storage time, which can only be maintained for about a week, so it is not only frequent in construction. And the overall cost is relatively high.

Why cleaning and waxing can not be used as a treatment method of stone surface, the main reason is that it can not really solve the technical problems of diamond grinding sheet, the reason why the diamond grinding sheet can be crystal clear and bright as a mirror, the main reason is that the diamond grinding sheet is after mechanical processing, will form a layer of glassy film on its surface, Because this film has the gloss of the mirror and is relatively transparent, it can well show the level and pattern of the internal structure of the stone, the beauty of the whole is mainly here, and ensure that the stone can quickly restore its beautiful beauty in the case of abrasion and weathering. The most important thing is to re-form a glassy film on the surface of the grinding plate.

The main maintenance methods and requirements of the use of diamond water grinding disc are introduced

If you do not need to use the diamond wet polishing pads immediately, you should first put it flat on the table, or use its own inner hole to hang it up, the flat diamond water grinding sheet above can not be stacked with any other items, or use your feet to step, but also pay attention to its moisture and rust prevention.

The blade of the diamond polishing disc is not sharp enough, and the diamond grinding disc must first be polished, because the diamond grinding process will not cause damage to the diamond grinding disc, and will not change its original Angle.

If it is necessary to process the positioning hole of the diamond grinding disc or correct the inner diameter, this work must be completed by the manufacturer, because the occurrence of poor processing will affect the use effect of the entire product in the future, and unnecessary dangerous accidents will occur in serious cases. In principle, reaming can not exceed 20mm of the inner diameter of the original hole. The main fear is that it will affect the balance of stress.